NAVPOD RAIL MOUNT PRE-CUT FOR RAYMARINE

NAVPOD RAIL MOUNT PRE-CUT FOR RAYMARINE RailMount Pre-Cut for Raymarine Axiom 7 & Axiom+ 7 RailMount Pre-Cut for Raymarine Axiom 7 and Axiom+ 7 only NO SONAR-NOT FOR AXIOM 7 DV or AXIOM 7 RV (Requires Part# R70561 Right Angled Cable) (Pre-Cut is for Surface Mount) (fits 1 or 1.25 tubing) RailMount NavPods are best used for mounting an autopilot control, sailing instrument, or small chartplotter onto an existing pedestal guard. Fits onto any 1, 1.125, or 1.25 diameter tube. A Stainless Steel arm is used to mount the NavPod housing. The NavPod can rotate 180 degrees for easy viewing while sitting under the dodger on a rainy day. All wiring runs from the NavPod, down the center of the stainless steel arm (available space is 0.75 inside the narrowest part of the arm, so keep this in mind for planning your cable run; most transducer cables will not fit through the arm), and into the pedestal guard. This application provides a clean and sturdy installation for electronics, without the replac